2007 Infiniti FX45FACTORY OEM SERVICE PROCEDURE

Revolution Sensor Components (2WD Models Only): Installation

CAUTION: After completing installation, check A/T position, A/T fluid leakage and A/F fluid level. Refer to "CHECKING OF A/T POSITIONΒ ", "CHECKING A/T FLUIDΒ ".
  1. Install revolution sensor in transmission case, and then tighten revolution sensor mounting bolt to the specified torque. Refer to "COMPONENTSΒ ".
    CAUTION:
    • Do not subject it to impact by dropping or hitting it.
    • Do not disassemble.
    • Do not allow metal filings, etc. to get on the sensor's front edge magnetic area.
    • Do not place in an area affected by magnetism.
    • Fig 1: Identifying Revolution Sensor In Transmission Case
      G04875992Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Connect revolution sensor connector.
    Fig 2: Identifying Revolution Sensor Connector
    G04875913Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Securely fasten revolution sensor harness with clip.
    Fig 3: Identifying Terminal Clip And Revolution Sensor Connector
    G04875914Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Apply recommended sealant (Genuine Anaerobic Liquid Gasket or equivalent. Refer to "RECOMMENDED CHEMICAL PRODUCTS AND SEALANTS ".) to rear extension assembly as shown in the figure.
    CAUTION: Completely remove all moisture, oil and old sealant, etc. from transmission case and rear extension assembly mounting surfaces.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.