Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Check Encoder Circuit (Driver Side)
- CHECK FRONT POWER WINDOW MOTOR (DRIVER SIDE) POWER SUPPLY
- Turn ignition switch ON.
- Check voltage between front power window motor (driver side) connector D8 terminal 4 and ground.
4 (W) - Ground : Approx. 10V
OK or NG
OK: GO TO 3.
NG: GO TO 2.
- CHECK HARNESS CONTINUITY 1
- Turn ignition switch OFF.
- Disconnect power window main switch and front power window motor (driver side).
- Check continuity between power window main switch connector D6 terminal 15 and front power window motor (driver side) connector D8 terminal 4.
15 (W) - 4 (W) : Continuity should exist.
OK or NG
OK: Replace power window main switch.
NG: Repair or replace harness.
- CHECK GROUND CIRCUIT
- Turn ignition switch OFF.
- Disconnect front power window motor (driver side) connector.
- Check continuity between front power window motor (driver side) connector D8 terminal 6 and ground.
6 (SB) - Ground : Continuity should exist.
OK or NG
OK: GO TO 5.
NG: GO TO 4.
- CHECK HARNESS CONTINUITY 2
- Disconnect power window main switch connector.
- Check continuity between power window main switch connector D6 terminal 2 and front power window motor (driver side) connector D8 terminal 6.
2 (SB) - 6 (SB) : Continuity should exist.
OK or NG
OK: Replace power window main switch.
NG: Repair or replace harness.
- CHECK ENCODER SIGNAL
- Connect front power window motor (driver side) connector.
- Turn ignition switch ON.
- Check signal between power window main switch connector and ground with oscilloscope.
ENCODER SIGNALConnector Terminals (Wire color) Condition Signal (Reference value) (+) (-) D6 13 (PU) Ground Window DOWN OK or NG
OK: Replace power window main switch.
NG: GO TO 6.
- CHECK HARNESS CONTINUITY 3
- Turn ignition switch OFF.
- Disconnect power window main switch and front power window motor (driver side) connector.
- Check continuity between power window main switch connector D6 terminal 13 and front power window motor (driver side) connector D8 terminal 3.
13 (PU) - 3 (PU) : Continuity should exist.
OK or NG
OK: Replace front power window motor (driver side).
NG: Repair or replace harness.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
