Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Infiniti FX45FACTORY OEM SERVICE PROCEDURE
CONSULT-II Function (BCM): Notes
CONSULT-II can display each diagnostic item using the diagnostic test modes shown following.
DIAGNOSTIC TEST MODES
| BCM diagnosis position | Inspection items and diagnosis mode | Description | ||
|---|---|---|---|---|
| BCM C/U(1) | Self-diagnosis results | Carries out the self-diagnosis. | ||
| DATA MONITOR | Displays the input data to BCM on real-time basis. | |||
| CAN DIAG SUPPORT MNTR | Displays CAN communication system diagnosis, disabled transmission status, and communication status of each unit communicated with BCM. | |||
| MULTI REMOTE ENT | DATA MONITOR | Displays the input remote keyless entry system data to BCM on real-time basis. | ||
| ACTIVE TEST | Gives a drive to a load to check the operation. | |||
| WORK SUPPORT | Changes the setting for each function. | |||
|
||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.