2006 Infiniti M35 BaseFACTORY OEM SERVICE PROCEDURE

CAN Communication Inspection Using CONSULT-II (Self-Diagnosis)

WARNING: This page is about a different car, the 2006 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.
  1. SELF-DIAGNOSTIC RESULT CHECK
    CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.
    1. Connect to CONSULT-II, and select "BCM" on "SELECT SYSTEM" screen.
    2. Select "BCM" on "SELECT TEST ITEM" screen, and select "SELF-DIAG RESULTS".
    3. Check display content in self-diagnostic results.
      DISPLAY CONTENT IN SELF-DIAGNOSTIC RESULTS

      CONSULT-II display code Diagnosis item
      U1000 INITIAL DIAG
      TRANSMIT DIAG
      ECM
      IPDM E/R
      METER/M&A
      I-KEY

    Contents displayed 

    • No malfunction : Inspection End
    • Malfunction in CAN communication system : After printing the monitor items, go to "CAN COMMUNICATION ".
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.