2005 Infiniti G35 xFACTORY OEM SERVICE PROCEDURE

With GST

  1. Check the coolant level in the reservoir tank and radiator.

    Allow engine to cool before checking coolant level. 

    If the coolant level in the reservoir tank and/or radiator is below the proper range, skip the following steps and go to "Diagnostic Procedure ".

  2. Confirm whether customer filled the coolant or not. If customer filled the coolant, skip the following steps and go to "Diagnostic Procedure ".
  3. Start engine.
    CAUTION: Be careful not to overheat engine.
  4. Turn air conditioner switch ON.
  5. Turn blower fan switch ON.
    Fig 1: Locating OK Zone On Coolant Reservoir Tank
    G02348824Courtesy of NISSAN MOTOR CO., U.S.A.
  6. Make sure that cooling fan operates at low speed.

    If NG, go to "Diagnostic Procedure ".

    If OK, go to the following step.

    Turn ignition switch OFF.

  7. Turn air conditioner switch and blower fan switch OFF.
  8. Disconnect engine coolant temperature sensor harness connector.
  9. Connect 150Ω resistor to engine coolant temperature sensor harness connector.
    Fig 2: Locating Cooling Fan Speed And A/C Switch
    G02348825Courtesy of NISSAN MOTOR CO., U.S.A.
  10. Restart engine and make sure that cooling fan operates at higher speed than low speed.
    CAUTION: Be careful not to overheat engine.
  11. If NG, go to "Diagnostic Procedure ".
    Fig 3: Connecting 150Ω Resistor To Engine Coolant Temperature Sensor Harness Connector
    G02348826Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.