Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Infiniti FX45FACTORY OEM SERVICE PROCEDURE
Control Device Removal and Installation: Removal
- Disconnect lower lever of control device and control rod.
- Remove knob cover below selector lever knob downward.
- Pull lock pin out of selector lever knob.
- Remove selector lever knob.
- Remove console finisher.
- Refer to "COMPONENT PARTS DRAWING ".
- Remove center console.
- Refer to "COMPONENT PARTS DRAWING ".
- Remove key interlock cable from control device.
- Refer to "REMOVAL AND INSTALLATIONΒ ".
- Disconnect A/T device harness connector.
- Remove control device assembly.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
