Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Infiniti FX45FACTORY OEM SERVICE PROCEDURE
Automatic Transmission: Disassembly: Disassembly
CAUTION:
Do not disassemble parts behind Drum Support. Refer to
"CROSS-SECTIONAL VIEW (2WD MODELS)Β " or
"CROSS-SECTIONAL VIEW (AWD MODELS)Β ".
- Drain ATF through drain plug.
- Remove torque converter by holding it firmly and turning while pulling straight out.
- Check torque converter one-way clutch using check tool as shown in the figure.
- Insert check tool into the groove of bearing support built into one-way clutch outer race.
- When fixing bearing support with check tool, rotate one-way clutch spline using screwdriver.
- Make sure that inner race rotates clockwise only. If not, replace torque converter assembly.
- Remove converter housing from transmission case.CAUTION: Be careful not to scratch converter housing.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
