Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Infiniti FX45FACTORY OEM SERVICE PROCEDURE
Diagnostic Procedure
- CHECK DTC
With CONSULT-II
- Turn ignition switch ON. (Do not start engine.)
- Select "SELF DIAG RESULTS" mode for "A/T" with CONSULT-II.
- Touch "ERASE".
- Turn ignition switch OFF and wait at least 10 seconds.
- Perform "DTC confirmation procedure", "DTC CONFIRMATION PROCEDURE ".
Is the "TCM.ROM" displayed again?
- YES: Replace the control valve with TCM. Refer to "CONTROL VALVE WITH TCM AND A/T FLUID TEMPERATURE SENSOR 2 ".
- NO: INSPECTION END
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
