2005 Infiniti FX45FACTORY OEM SERVICE PROCEDURE

DTC Confirmation Procedure: Notes

NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

WITH CONSULT-II 

  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT-II.
  3. Wait at least 10 seconds. If the result is NG, go to "DIAGNOSTIC PROCEDURE  ". If the result is OK, go to following step.
  4. Check "COOLAN TEMP/S" value.

    If "COOLAN TEMP/S" is less than 60°C (140°F), the result will be OK.

    If "COOLAN TEMP/S" is above 60°C (140°F), go to the following step.

    Fig 1: Identifying Consult-II Data Monitor
    G02361671Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Cool engine down until "COOLAN TEMP/S" is less than 60°C (140°F).
  6. Wait at least 10 seconds.
  7. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE  ".
Chapter Navigation
Return to Chapter: DTC Confirmation Procedure
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.