2005 Infiniti FX45FACTORY OEM SERVICE PROCEDURE

With CONSULT-II

  1. Perform "ACCELERATOR PEDAL RELEASED POSITION LEARNING  ".
  2. Perform "THROTTLE VALVE CLOSED POSITION LEARNING  ".
  3. Start engine and warm it up to normal operating temperature.
  4. Check that all items listed under the topic PREPARATION (previously mentioned) are in good order.
  5. Select "IDLE AIR VOL LEARN" in "WORK SUPPORT" mode.
    Fig 1: Identifying CONSULT-II Display Screen Idle Air Vol Learn
    G02361306Courtesy of NISSAN MOTOR CO., U.S.A.
  6. Touch "START" and wait 20 seconds.
    Fig 2: Identifying CONSULT-II Display Screen Work Support (1 Of 2)
    G02361307Courtesy of NISSAN MOTOR CO., U.S.A.
  7. Make sure that "CMPLT" is displayed on CONSULT-II screen. If "CMPLT" is not displayed, Idle Air Volume Learning will not be carried out successfully. In this case, find the cause of the incident by referring to the DIAGNOSTIC PROCEDURE below.
  8. Rev up the engine two or three times and make sure that idle speed and ignition timing are within the specifications.
    IDLE SPEED AND IGNITION TIMING SPECIFICATION

    ITEM SPECIFICATION
    Idle speed 650 +/- 50 rpm (in P or N position)
    Ignition timing 12 +/- 5° BTDC (in P or N position)
    Fig 3: Identifying CONSULT-II Display Screen Work Support (2 Of 2)
    G02361308Courtesy of NISSAN MOTOR CO., U.S.A.
Chapter Navigation
Return to Chapter: Operation Procedure
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.