2005 Infiniti FX45FACTORY OEM SERVICE PROCEDURE

Encoder Circuit Check (Driver Side)

  1. CHECK FRONT POWER WINDOW MOTOR (DRIVER SIDE) POWER SUPPLY 
    1. Turn ignition switch ON.
    2. Check voltage between front power window motor (driver side) connector D8 terminal 4 and ground.
      1. 4 (W) - Ground: Approx. 10V 

    OK or NG 

    1. OK: GO TO  3 .
    2. NG: GO TO 2.
    Fig 1: Checking Voltage Between Front Power Window Motor (Driver Side) Connector D8 Terminal 4 And Ground
    G02364009Courtesy of NISSAN MOTOR CO., U.S.A.
  2. CHECK HARNESS CONTINUITY 1 
    1. Turn ignition switch OFF.
    2. Disconnect power window main switch and front power window motor (driver side).
    3. Check continuity between power window main switch connector D6 terminal 15 and front power window motor (driver side) connector D8 terminal 4.
      1. 15 (W) - 4 (W): Continuity should exist. 

    OK or NG 

    1. OK: Replace power window main switch.
    2. NG: Repair or replace harness.
    Fig 2: Checking Harness Continuity
    G02364010Courtesy of NISSAN MOTOR CO., U.S.A.
  3. CHECK GROUND CIRCUIT 
    1. Turn ignition switch OFF.
    2. Disconnect front power window motor (driver side) connector.
    3. Check continuity between front power window motor (driver side) connector D8 terminal 6 and ground.
      1. 6 (SB) - Ground: Continuity should exist. 

    OK or NG 

    1. OK: GO TO  5 .
    2. NG: GO TO 4.
    Fig 3: Checking Continuity Between Front Power Window Motor (Driver Side) Connector D8 Terminal 6 And Ground
    G02364011Courtesy of NISSAN MOTOR CO., U.S.A.
  4. CHECK HARNESS CONTINUITY 2 
    1. Disconnect power window main switch connector.
    2. Check continuity between power window main switch connector D6 terminal 2 and front power window motor (driver side) connector D8 terminal 6.
      1. 2 (SB) - 6 (SB): Continuity should exist. 

    OK or NG 

    1. OK: Replace power window main switch.
    2. NG: Repair or replace harness.
    Fig 4: Checking Harness Continuity 2
    G02364012Courtesy of NISSAN MOTOR CO., U.S.A.
  5. CHECK ENCODER SIGNAL 
    1. Connect front power window motor (driver side) connector.
    2. Turn ignition switch ON.
    3. Check signal between power window main switch connector and ground with oscilloscope.
      Fig 5: Connector Terminal Wire Color Specification
      G02364013Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.