Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
7. Check Injector
- Turn ignition switch OFF.
- Remove injector assembly.
Refer to FUEL INJECTOR AND FUEL TUBE .
Keep fuel hose and all injectors connected to injector gallery.
- Reconnect all injector harness connectors disconnected.
- Disconnect all ignition coil harness connectors.
- Turn ignition switch ON.
Make sure fuel does not drip from injector.
OK or NG
OK (Does not drip.): GO TO 8.
NG (Drips.):Replace the injector(s) from which fuel is dripping.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.