2004 Infiniti Q45FACTORY OEM SERVICE PROCEDURE

5. Check Injectors

  1. Stop engine and then turn ignition switch ON.
  2. Check voltage between ECM terminals 5, 6, 7,13,14,15,16,17 and ground with CONSULT-II or tester.
    1. Voltage: Battery voltage 
    Fig 1: Checking voltage between ECM terminals 5, 6, 7,13,14,15,16,17 & ground
    G00760901Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Refer to Wiring Diagram for Injectors, Wiring Diagram  .

OK or NG 

OK : GO TO 6.

NG : Perform Diagnostic Procedure  .

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.