Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
6. Check Intake Valve Timing Control Position Sensor Input Signal Circuit For Open And Short
- Disconnect ECM harness connector.
- Check harness continuity between the following;
ECM terminal 73 (bank 1) and intake valve timing control position sensor terminal 2 or
ECM terminal 74 (bank 2) and intake valve timing control position sensor terminal 2.
Refer to Wiring Diagram.
- Continuity should exist.Β
- Also check harness for short to ground and short to power.
OK or NGΒ
OK: GO TO 7.
NG: Repair open circuit or short to ground or short to power in harness or connectors.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
