2004 Infiniti Q45FACTORY OEM SERVICE PROCEDURE

1. Check Refrigerant Pressure Sensor Overall Function

  1. Start engine and warm it up to normal operating temperature.
  2. Turn A/C switch and blower switch ON.
  3. Check voltage between ECM terminal 88 and ground with CONSULT-II or tester.
    1. Voltage: 1.0 - 4.0V 
Fig 1: Checking voltage between ECM terminal 88 & ground
G00761397Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: INSPECTION END 

NG: GO TO 2.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.