2004 Infiniti Q45FACTORY OEM SERVICE PROCEDURE

DTC Confirmation Procedure

TESTING CONDITION: 

Before performing the following procedure, confirm that battery voltage is more than 10.5V at idle. 

With CONSULT-II 

  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT-II.
  3. Start engine and let it idle for at least 10 seconds.
  4. If a 1st trip DTC is detected, go to Diagnostic Procedure  .

With GST 

Follow the procedure With CONSULT-II above.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.