2004 Infiniti Q45FACTORY OEM SERVICE PROCEDURE

Throttle Control Motor

  1. Disconnect electric throttle control actuator harness connector.
  2. Check resistance between terminals 3 and 6.
    Fig 1: Checking resistance between terminals 3 & 6
    G00760543Courtesy of NISSAN MOTOR CO., U.S.A.
    1. Resistance: Approximately 1 - 15 Ω [at 25 °C (77°F)] 
  3. If NG, replace electric throttle control actuator and go to next step.
  4. Perform ACCELERATOR PEDAL RELEASED POSITION LEARNING 
  5. Perform THROTTLE VALVE CLOSED POSITION LEARNING  .
  6. Perform IDLE AIR VOLUME LEARNING  .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.