2004 Infiniti Q45FACTORY OEM SERVICE PROCEDURE

Work Flow

  1. Check the symptom and customer's requests.
  2. Understand the outline of system. Refer to SYSTEM DESCRIPTION  .
  3. Perform the preliminary check. Refer to PRELIMINARY CHECK  .
  4. Perform the communication inspection. If CONSULT-II is used, refer to IVMS COMMUNICATION INSPECTION  . If CONSULT-II is not used, refer to COMMUNICATION DIAGNOSIS  . Is the communication diagnosis result OK?
    1. OK: GO TO step 7.
    2. NG: GO TO step 5.
  5. Repair or replace depending on the diagnosis result.
  6. Perform the communication diagnosis again. If CONSULT-II is used, refer to IVMS COMMUNICATION INSPECTION  . If CONSULT-II is not used, refer to COMMUNICATION DIAGNOSIS  . Is communication diagnosis result OK?
    1. OK: GO TO step 7.
    2. NG: GO TO step 5.
  7. Referring to Trouble diagnosis chart, repair or replace the cause of the incident. Refer to TROUBLE DIAGNOSIS CHART BY SYMPTOM  .
  8. Does the remote keyless entry system operate normally?
    1. YES: GO TO step 9.
    2. NO: GO TO step 7.
  9. Inspection end.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.