2004 Infiniti Q45FACTORY OEM SERVICE PROCEDURE

4. Check Remote Keyless Entry Receiver Harness

  1. Disconnect BCM and remote keyless entry receiver connector.
  2. Check continuity between remote keyless entry receiver connector B246 terminal 2 (BR/W) and BCM connector M4 terminal 27 (BR/W).
    1. 27 (BR/W) - 2 (BR/W) : Continuity should exist  .
  3. Check continuity between BCM connector M4 terminal 27 (BR/W) and ground.
    1. 27 (BR/W) - Ground : Continuity should not exist  .

OK or NG 

  1. OK: Replace remote keyless entry receiver.
  2. NG: Repair or replace harness.
Fig 1: Checking Remote Keyless Entry Receiver Harness
G00741523Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.