Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Infiniti Q45FACTORY OEM SERVICE PROCEDURE
3. Check Remote Keyless Entry Receiver Harness
- Disconnect BCM and remote keyless entry receiver connector.
- Check continuity between BCM connector M4 terminal 44 (Y) and remote keyless entry receiver connector B246 terminal 1 (Y).
- 44 (Y) - 1 (Y) : Continuity should exist .
- Check continuity between BCM connector M4 terminal 44 (Y) and ground.
- 44 (Y) - Ground : Continuity should not exist .
OK or NG
- OK: Remote keyless entry receiver circuit is OK.
- NG: Repair or replace harness.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
