Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Infiniti Q45FACTORY OEM SERVICE PROCEDURE
2. Check Key Switch Circuit
- Disconnect key switch connector.
- Check continuity between BCM connector M4 terminal 69 (PU/W) and key switch connector M64 terminal 4 (PU/W).
- 69 (PU/W) - 4 (PU/W) : Continuity should exist .
- Check continuity between BCM connector M4 terminal 69 (PU/W) and ground.
- 69 (PU/W) - Ground : Continuity should not exist .
OK or NG
- OK: GO TO 3.
- NG: Repair or replace harness.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
