2004 Infiniti Q45FACTORY OEM SERVICE PROCEDURE

3. Check Encoder Ground

  1. Turn ignition switch OFF.
  2. Disconnect auto trunk motor connector.
  3. Check continuity between auto trunk motor connector B109 terminal 9 and ground.
    1. 9 (R/W) - Ground : Continuity should exist  .

OK or NG 

  1. OK : GO TO 5.
  2. NG : GO TO 4.
Fig 1: Checking Continuity Between Auto Trunk Motor Connector B109 Terminal 9 And Ground
G00741021Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.