2004 Infiniti Q45FACTORY OEM SERVICE PROCEDURE

2. Check Key Switch Circuit

  1. Disconnect key switch connector.
  2. Check continuity between BCM connector M4 terminal 69 (PU/W) and key switch connector M64 terminal 4 (PU/W).
    1. 69 (PU/W) - 4 (PU/W) : Continuity should exist  .
  3. Check continuity between BCM connector M4 terminal 69 (PU/W) and ground.
    1. 69 (PU/W) - Ground : Continuity should not exist  .

OK or NG 

  1. OK: GO TO 3.
  2. NG: Repair or replace harness.
Fig 1: Checking Key Switch Circuit
G00741486Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.