2004 Infiniti M45FACTORY OEM SERVICE PROCEDURE

2. Check Throttle Position Sensor Power Supply Circuit

  1. Disconnect electric throttle control actuator harness connector.
    Fig 1: Identifying Electric Throttle Control Actuator Harness Connector
    G00796607Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Turn ignition switch ON.
  3. Check voltage between electric throttle control actuator terminal 1 and ground with CONSULT-11 or tester.
    Fig 2: Checking Voltage Between Electric Throttle Control Actuator Terminal 1 & Ground
    G00796608Courtesy of NISSAN MOTOR CO., U.S.A.

    Voltage: Approximately 5VΒ 

OK or NGΒ 

  1. OK: GO TO 3.
  2. NG: Repair open circuit or short to ground or short to power in harness or connectors.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.