Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
7. Check Injector
- Turn ignition switch OFF.
- Remove injector assembly.
Refer to FUEL INJECTOR AND FUEL TUBE .
Keep fuel hose and all injectors connected to injector gallery.
- Disconnect all ignition coil harness connectors.
- Reconnect all injector harness connectors.
- Turn ignition switch ON.
Make sure fuel does not drip from injector.
OK or NG
- OK (Does not drip.):GO TO 8.
- NG (Drips.):Replace the injector(s) from which fuel is dripping.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.