2004 Infiniti M45FACTORY OEM SERVICE PROCEDURE

9. Check Injector

  1. Turn ignition switch OFF.
  2. Confirm that the engine is cooled down and there are no fire hazards near the vehicle.
  3. Remove injector assembly. Refer to FUEL INJECTOR AND FUEL TUBE . Keep fuel house and all injectors connected to injector gallery.
  4. Disconnect all injector harness connectors.
  5. Disconnect all ignition coil harness connectors.
  6. Prepare pans or saucers under each injectors.
  7. Crank engine for about 3 seconds. Make sure fuel does not drip from injector.

OK or NGΒ 

  1. OK (Does not drip.): GO TO 10.
  2. NG (Drips.): Replace the injectors from which fuel is dripping. Always replace O-ring with new one.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.