Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Infiniti M45FACTORY OEM SERVICE PROCEDURE
Diagnostic Procedure
- Check Ground ConnectionsÂ
- Turn ignition switch OFF.
- Loosen and retighten two ground screws.
Refer to GROUND INSPECTIONÂ .
- OK or NGÂ
- OK: GO TO 2.
- NG: Repair or replace ground connections.
- Check Intake Air Temperature Sensor Power Supply CircuitÂ
- Disconnect mass air flow sensor (intake air temperature sensor is built-into) harness connector.
- Turn ignition switch ON.
- Check voltage between mass air flow sensor terminal 5 and ground.
- Voltage: Approximately 5VÂ
- OK or NGÂ
- OK: GO TO 3.
- NG: Repair open circuit or short to ground or short to power in harness or connectors.
- Check Intake Air Temperature Sensor Ground Circuit For Open And ShortÂ
- Turn ignition switch OFF.
- Disconnect ECM harness connector.
- Check harness continuity between mass air flow sensor terminal 3 and ECM terminal 109.
For wiring diagram, refer to WIRING DIAGRAMÂ .
Continuity should exist.Â
- Also check harness for short to ground and short to power.
- OK or NGÂ
- OK: GO TO 4.
- NG: Repair open circuit or short to ground or short to power in harness or connectors.
- Check Intake Air Temperature SensorÂ
Refer to DIAGNOSTIC PROCEDUREÂ .
- OK or NGÂ
- OK: GO TO 5.
- NG: Replace mass air flow sensor (with intake air temperature sensor).
- Check Intermittent IncidentÂ
Refer to TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENTÂ .
- : INSPECTION ENDÂ
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
