2004 Infiniti I35FACTORY OEM SERVICE PROCEDURE

On-Vehicle Service: Installation

  • Drive plate runout
    CAUTION: Do not allow any magnetic materials to contact the ring gear teeth.
    1. Maximum allowable runout: Refer to DRIVE PLATE RUNOUT .
  • If this runout is outside the standard, replace drive plate and ring gear.
    Fig 1: Measuring Drive Plate Runout Using Dial Indicator
    G00792635Courtesy of NISSAN MOTOR CO., U.S.A.
  • When connecting torque converter to transaxle, measure distance "A" to be certain that they are correctly assembled.
    1. Distance "A":14 mm (0.55 in) or more 
    Fig 2: Measuring Distance A Of Torque Converter
    G00792636Courtesy of NISSAN MOTOR CO., U.S.A.
  • Install bolts fixing converter to drive plate.
  • With converter installed, rotate crankshaft several turns to check that transaxle rotates freely without binding. 
    Fig 3: Installing Bolt Fixing Converter Toi Drive Plate
    G00792637Courtesy of NISSAN MOTOR CO., U.S.A.
  • Tighten bolts securing transaxle.
  • Tighten LH mounting bracket bolts to the specified torque. Refer to REMOVAL AND INSTALLATION .
  • Tighten center member bolts to the specified torque. Refer to REMOVAL AND INSTALLATION .
  • Tighten rear plate cover bolts to the specified torque. Refer to OIL PAN .
    Fig 4: Identifying Bolt Length And Tightening Torque
    G00792638Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.