2004 Infiniti I35FACTORY OEM SERVICE PROCEDURE

Automatic Transmission DTCS

NOTE: Retrieval of some diagnostic codes may require the use of special OEM tester or flash method using instrument cluster indicator. For procedures/testing of codes not shown below, refer to appropriate system article.
AUTOMATIC TRANSMISSION DIAGNOSTIC TROUBLE CODES (DTC) IDENTIFICATION

DTC Description
DTC U1000 CAN COMMUNICATION LINE
DTC P0705 PARK/NEUTRAL POSITION SWITCH
DTC P0710 A/T FLUID TEMPERATURE SENSOR CIRCUIT
DTC P0720 VEHICLE SPEED SENSOR A/T (REVOLUTION SENSOR)
DTC P0725 ENGINE SPEED SIGNAL
DTC P0731 A/T 1ST GEAR FUNCTION
DTC P0732 A/T 2ND GEAR FUNCTION
DTC P0733 A/T 3RD GEAR FUNCTION
DTC P0734 A/T 4TH GEAR FUNCTION
DTC P0740 TORQUE CONVERTER CLUTCH SOLENOID VALVE
DTC P0744 A/T TCC S/V FUNCTION (LOCK UP)
DTC P0745 LINE PRESSURE SOLENOID VALVE
DTC P0750 SHIFT SOLENOID VALVE A
DTC P0755 SHIFT SOLENOID VALVE B
DTC P1705 ACCELERATOR PEDAL POSITION SENSOR (THROTTLE POSITION SENSOR)
DTC P1760 OVERRUN CLUTCH SOLENOID VALVE
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.