2004 Infiniti I35FACTORY OEM SERVICE PROCEDURE

DTC Confirmation Procedure

NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. See Figure .

WITH CONSULT-II 

  1. Turn ignition switch ON.
  2. Select DATA MONITOR mode with CONSULT-II.
  3. Wait at least 5 seconds.
  4. If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE  .

    WITH GST 

    Follow the procedure WITH CONSULT-II above.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.