Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Procedure
- CHECK OVERALL FUNCTION
Check ASCD indicator under the following conditions.
OK or NG
- OK: INSPECTION END
- NG: GO TO 2.
- CHECK COMBINATION METER OPERATION
Check that combination meter operates normally.
OK or NG
- OK: GO TO 3.
- NG: Check combination meter circuit. Refer to WIRING DIAGRAM -- METER -- .
- CHECK INDICATOR CIRCUIT
- Turn ignition switch ON.
- Check voltage between ECM terminals 24, 25 and ground with CONSULT-II or tester.
Battery voltage should exist.
OK or NG
- OK: GO TO 5 .
- NG: GO TO 4.
- DETECT MALFUNCTIONING PART
Check the following.
- Harness connectors F53, M223
- Harness for open or short between combination meter and ECM
- : Repair open circuit or short to ground or short to power in harness or connectors.
- CHECK INTERMITTENT INCIDENT
Refer to TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT .
- : INSPECTION END
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
