Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Procedure
- CHECK EXHAUST SYSTEMÂ
Visually check exhaust tubes and muffler for dent.
OK or NGÂ
- OK: GO TO 2.
- NG: Repair or replace.
- CHECK EXHAUST GAS LEAKÂ
- Start engine and run it at idle.
- Listen for an exhaust gas leak before the three way catalyst (manifold).
OK or NGÂ
- OK: GO TO 3.
- NG: Repair or replace.
- CHECK INTAKE AIR LEAKÂ
Listen for an intake air leak after the mass air flow sensor.
OK or NGÂ
- OK: GO TO 4.
- NG: Repair or replace.
- CHECK IGNITION TIMINGÂ
Check the following items. Refer to BASIC INSPECTIONÂ .
OK or NGÂ
- OK: GO TO 5.
- NG: Follow the Basic Inspection.
- CHECK INJECTORSÂ
- Refer to WIRING DIAGRAMÂ for Injectors, .
- Stop engine and then turn ignition switch ON.
- Check voltage between ECM terminals 1, 2, 3, 11, 12, 13 and ground with CONSULT-II or tester.
OK or NGÂ
- OK: GO TO 6.
- NG: Perform DIAGNOSTIC PROCEDUREÂ .
- CHECK IGNITION SPARKÂ
- Turn ignition switch OFF.
- Disconnect ignition coil assembly from rocker cover.
- Connect a known good spark plug to the ignition coil assembly.
- Place end of spark plug against a suitable ground and crank engine.
- Check for spark.
OK or NGÂ
- OK: GO TO 7.
- NG: Check ignition coil with power transistor and their circuit. Refer to IGNITION SIGNALÂ .
- CHECK INJECTORÂ
- Turn ignition switch OFF.
- Remove injector assembly.
Refer to INJECTORÂ .
Keep fuel hose and all injectors connected to injector gallery.
- Disconnect all ignition coil harness connectors.
- Turn ignition switch ON.
Make sure fuel does not drip from injector.
OK or NGÂ
- OK (Does not drip.): GO TO 8.
- NG (Drips.): Replace the injector(s) from which fuel is dripping.
- CHECK INTERMITTENT INCIDENTÂ
Refer to TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENTÂ .
- Trouble is fixed.: INSPECTION ENDÂ
- Trouble is not fixed.: Replace three way catalyst (manifold).
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
