Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Testing Condition
- For best results, perform at ambient temperature of - 10° C (14° F) or higher.
- For best results, perform at engine coolant temperature of - 10° C (14° F) to 60° C (140° F).
WITH CONSULT-II
- Replace thermostat with new one. Refer to THERMOSTAT . Use only a genuine NISSAN thermostat as a replacement. If an incorrect thermostat is used, the MIL may come on.
- Turn ignition switch ON.
- Select COOLAN TEMP/S in DATA MONITOR mode with CONSULT-II.
- Check that the COOLAN TEMP/S is above 60° C (140° F).
If it is below 60° C (140° F), go to following step.
If it is above 60° C (140° F), stop engine and cool down the engine to less than 60° C (140° F), then retry from step 1.
- Drive vehicle for 10 consecutive minutes under the following conditions.
If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE .
WITH GST
- Follow the procedure WITH CONSULT-II.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.