Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Infiniti I35FACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS LOCATION
| Component | Location |
|---|---|
| ABS Actuator (E168, E169) | At left rear of engine compartment, near brake master cylinder. See Figure . |
| ABS/TCS Control Unit | At left rear corner of engine compartment. See Figure . |
| A/C Auto Amplifier | Behind center of dash. See Figure . |
| Air Bag Diagnosis Sensor Unit | Under rear of center console. See Figure . |
| Audio Unit | Behind center of dash. See Figure . |
| Daytime Light Control Unit (Canada) | At right front corner of engine compartment. See Figure . |
| ECM | Behind instrument lower cover. See Figure . |
| Front Monitor | Upper center of dash. See Figure . |
| Heater Unit | Behind instrument lower cover. See Figure . |
| IVIS IMMU | On ignition key cylinder. See Figure . |
| Left Seat Control Unit | Under driver seat. See Figure . |
| NAVI Control Unit | Behind center of dash. See Figure . |
| Passenger Air Bag Module (149) | Right side of dash. See Figure . |
| Shift Lock Control Unit | Below center console. See Figure . |
| Smart Entrance Control Unit | Behind lower center of dash. See Figure . |
| Transmission Control Module (TCM) | Behind lower center of dash. See Figure . |
| VDC/TCS/ABS Control Unit | Under driver seat. See Figure . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
