Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Infiniti I35FACTORY OEM SERVICE PROCEDURE
Repair For Component Parts: Inspection: Notes
Low and Reverse Brake Snap Ring, Spring Retainer and Return Springs
- Check for deformation, fatigue or damage.
If necessary, replace.
- When replacing spring retainer and return springs, replace them as a set.
Low and Reverse Brake Drive Plate
- Check facing for burns, cracks or damage.
- Measure thickness of facing.
- Thickness of drive plate: Standard value 1.8 mm (0.071 in)
- Wear limit 1.6 mm (0.063 in)
- If not within wear limit, replace.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
