Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Procedure
- RETIGHTEN GROUND SCREWSÂ
- Turn ignition switch OFF.
- Loosen and retighten engine ground screws. See Figure .
- : GO TO 2.
- CHECK THROTTLE POSITION SENSOR POWER SUPPLY CIRCUITÂ
- Disconnect electric throttle control actuator harness connector. See Figure .
- Turn ignition switch ON.
- Check voltage between electric throttle control actuator terminal 1 and ground with CONSULT-II or tester.
Voltage: Approximately 5VÂ
OK or NGÂ
- OK: GO TO 3.
- NG: Repair open circuit or short to ground or short to power in harness or connectors.
- CHECK THROTTLE POSITION SENSOR GROUND CIRCUIT FOR OPEN AND SHORTÂ
- Turn ignition switch OFF.
- Check harness continuity between electric throttle control actuator terminal 5 and engine ground.
Continuity should exist.Â
- Also check harness for short to ground and short to power.
OK or NGÂ
- OK: GO TO Â 5 .
- NG: GO TO 4.
- DETECT MALFUNCTIONING PARTÂ
Check the following.
- Joint connector-20
- Harness for open or short between electric throttle control actuator and ECM
- : Repair open circuit or short to ground or short to power in harness or connectors.
- CHECK THROTTLE POSITION SENSOR INPUT SIGNAL CIRCUIT FOR OPEN AND SHORTÂ
- Disconnect ECM harness connector.
- Check harness continuity between ECM terminal 83 and electric throttle control actuator terminal 4, ECM terminal 84 and electric throttle control actuator terminal 2.
Refer to wiring diagram
Continuity should exist.Â
- Also check harness for short to ground and short to power.
OK or NGÂ
- OK: GO TO 6.
- NG: Repair open circuit or short to ground or short to power in harness or connectors.
- CHECK THROTTLE POSITION SENSORÂ
Refer to Component Inspection, COMPONENT INSPECTIONÂ .
OK or NGÂ
- OK: GO TO Â 8 .
- NG: GO TO 7.
- REPLACE ELECTRIC THROTTLE CONTROL ACTUATORÂ
- Replace the electric throttle control actuator.
- Perform THROTTLE VALVE CLOSED POSITION LEARNINGÂ .
- Perform IDLE AIR VOLUME LEARNINGÂ .
- : INSPECTION END
- CHECK INTERMITTENT INCIDENTÂ
Refer to TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENTÂ .
- : INSPECTION END
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
