Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Procedure
- CHECK STOP LAMP SWITCH CIRCUITÂ
- Turn ignition switch OFF.
- Check the stop lamp when depressing and releasing the brake pedal.
OK or NGÂ
- OK: GO TO Â 4 .
- NG: GO TO 2.
- CHECK STOP LAMP SWITCH POWER SUPPLY CIRCUITÂ
- Disconnect stop lamp switch harness connector.
- Check voltage between stop lamp switch terminal 1 and ground with CONSULT-II or tester.
Voltage: Battery voltageÂ
OK or NGÂ
- OK: GO TO Â 4 .
- NG: GO TO 2.
- DETECT MALFUNCTIONING PARTÂ
Check the following.
- Harness connectors M15, E81
- 15A fuse
- Fuse block (J/B) connector M17
- Harness for open and short between stop lamp switch and battery
OK or NGÂ
- : Repair open circuit or short to ground or short to power in harness or connectors.
- CHECK STOP LAMP SWITCH INPUT SIGNAL CIRCUIT FOR OPEN AND SHORTÂ
- Turn ignition switch OFF.
- Disconnect ECM harness connector.
- Disconnect stop lamp switch harness connector. See Fig 2 .
- Check harness continuity between ECM terminal 55 and stop lamp switch terminal 2.
Refer to Wiring Diagram.
Continuity should exit.Â
- Also check harness for short to ground and short to power.
OK or NGÂ
- OK: GO TO Â 6 .
- NG: GO TO 5.
- DETECT MALFUNCTIONING PARTÂ
Check the following.
- Harness connectors E81, M15
- Harness connectors M223, F53
- Harness for open or short between ECM and stop lamp switch
OK or NGÂ
- OK: Repair open circuit or short to ground or short to power in harness or connectors.
- CHECK STOP LAMP SWITCHÂ
Refer to COMPONENT INSPECTIONÂ .
OK or NGÂ
- OK: GO TO 7.
- NG: Replace stop lamp switch.
- CHECK INTERMITTENT INCIDENTÂ
Refer to TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENTÂ .
OK or NGÂ
- : INSPECTION END
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
