Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Infiniti I35FACTORY OEM SERVICE PROCEDURE
Diagnostic Procedure
- CHECK VEHICLE SPEED SENSOR INPUT SIGNAL CIRCUIT FOR OPEN AND SHORTÂ
- Turn ignition switch OFF.
- Disconnect ECM harness connector and combination meter harness connector M32.
- Check harness continuity between ECM terminal 68 and combination meter terminal 32. Refer to Wiring Diagram.
Continuity should exist.Â
- Also check harness for short to power.
OK or NGÂ
- OK: GO TO Â 3 .
- NG: GO TO 2.
- DETECT MALFUNCTIONING PARTÂ
Check the following.
- Harness connectors M229, F66
- Harness for open or short between ECM and combination meter
- : Repair open circuit or short to ground or short to power in harness or connectors.
- CHECK COMBINATION METER FUNCTIONÂ
Make sure that speedometer functions properly.
OK or NGÂ
- OK: GO TO Â 5 .
- NG: GO TO 4.
- CHECK COMBINATION METER CIRCUIT FOR OPEN AND SHORTÂ
Check the following.
- Harness connectors M15, E81
- Harness connectors M230, F67
- Harness connectors F65, F114
- Harness for open or short between combination meter and vehicle speed sensor
- Harness for open or short between combination meter and ABS/TCS control unit
- Harness for open or short between vehicle speed sensor and ECM
- Harness for open or short between vehicle speed sensor and TCM (Transmission control module)
OK or NGÂ
- OK: Check combination meter and vehicle speed sensor or ABS/TCS control unit. Refer to EL section.
- NG: Repair open circuit or short to ground or short to power in harness or connectors.
- CHECK INTERMITTENT INCIDENTÂ
Refer to TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENTÂ .
- : INSPECTION ENDÂ
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
