Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Overall Function Check: Notes
Use this procedure to check the overall function of the fuel level sensor function. During this check, a 1st trip DTC might not be confirmed.
TESTING CONDITION:
Before starting overall function check, preparation of draining fuel and refilling fuel is required.
WITH CONSULT-II
- Prepare a fuel container and a spare hose.
- Release fuel pressure from fuel line, refer to FUEL PRESSURE RELEASE .
- Remove the fuel feed hose on the fuel level sensor unit.
- Connect a spare fuel hose where the fuel feed hose was removed.
- Turn ignition switch OFF and wait at least 10 seconds then turn ON.
- Select FUEL LEVEL SE in DATA MONITOR mode with CONSULT-II. See Figure .
- Check FUEL LEVEL SE output voltage and note it.
- Select FUEL PUMP in ACTIVE TEST mode with CONSULT-II.
- Touch ON and drain fuel approximately 30l (7-7/8 US gal, 6-5/8 Imp gal) and stop it.
- Fill fuel into the fuel tank for 30l (7-7/8 US gal, 6-5/8 Imp gal).
- Check FUEL LEVEL SE output voltage and note it.
- Check FUEL LEVEL SE output voltage and confirm whether the voltage changes more than 0.03V during step 7 to 11.
If NG, check the fuel level sensor, refer to FUEL LEVEL SENSOR UNIT CHECK .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
