Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Procedure
- CHECK FUEL LEVEL SENSOR POWER SUPPLY CIRCUITÂ
- Turn ignition switch off.
- Disconnect fuel level sensor unit and fuel pump harness connector.
- Turn ignition switch on.
- Check voltage between fuel level sensor unit and fuel pump terminal 2 and ground with CONSULT-II or a tester.
OK OR NGÂ
- OK: GO TO Â 3 .
- NG: GO TO 2.
- DETECT MALFUNCTIONING PARTÂ
Check the following.
- Harness connectors M6, B3
- Harness for open or short between combination meter and fuel level sensor unit and fuel pump
- : Repair or replace harness or connectors.
- CHECK FUEL LEVEL SENSOR GROUND CIRCUIT FOR OPEN AND SHORTÂ
- Turn ignition switch off.
- Check harness continuity between fuel level sensor unit and fuel pump terminal 5 and body ground. Refer to wiring diagram.
Continuity should exist.Â
- Also check harness for short to power.
OK OR NGÂ
- OK: GO TO 4.
- NG: repair open circuit or short to power in harness or connectors.
- CHECK FUEL LEVEL SENSOR INPUT SIGNAL CIRCUIT FOR OPEN AND SHORTÂ
- Disconnect ECM harness connector.
- Check harness continuity between ECM terminal 69 and fuel level sensor unit and fuel pump terminal 2, ECM terminal 78 and fuel level sensor unit and fuel pump terminal 5. Refer to wiring diagram.
Continuity should exist.Â
- Also check harness for short to ground and short to power.
OK OR NGÂ
- OK: GO TO Â 6 .
- NG: GO TO 5.
- DETECT MALFUNCTIONING PARTÂ
Check the following.
- Harness connectors M229, F66
- Harness connectors M6, B3
- Harness for open or short between ECM and fuel level sensor unit and fuel pump
- : Repair open circuit or short to ground or short to power in harness or connectors.
- CHECK FUEL LEVEL SENSORÂ
Refer to FUEL LEVEL SENSOR UNIT CHECK .
OK OR NGÂ
- OK: GO TO 7.
- NG: Replace fuel level sensor unit and fuel pump.
- CHECK INTERMITTENT INCIDENTÂ
Refer to TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENTÂ .
- : INSPECTION ENDÂ
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
