Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Infiniti I35FACTORY OEM SERVICE PROCEDURE
DTC Confirmation Procedure
NOTE:
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
TESTING CONDITION:
Always perform test at a temperature of 5° C (41° F) or more.
WITH CONSULT-II
- Start engine and warm it up to normal operating temperature
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Select DATA MONITOR mode with CONSULT-II.
- Make sure that FUEL T/TEMP SE is more than 0° C (32° F).
- Start engine and wait at least 20 seconds.
- If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE
.
If 1st trip DTC is not detected, go to next step.
- Stop engine and install EVAP service port adapter and pressure pump to EVAP service port securely.
- Pressurize the EVAP line using pressure pump.
- Confirm the pressure does not go up.
- If pressure go up, go to DIAGNOSTIC PROCEDURE .
WITH GST
- Start engine and warm it up to normal operating temperature.
- Check that voltage between ECM terminal 75 (Fuel tank temperature sensor signal) and ground is less than 4.2V.
- Turn ignition switch OFF and wait at least 10 seconds.
- Start engine and wait at least 20 seconds.
- Select MODE 7 with GST.
- If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
