2004 Infiniti I35FACTORY OEM SERVICE PROCEDURE

Testing Condition

Before performing the following procedure, confirm that battery voltage is more than 10.5V with ignition switch ON. 

With CONSULT-II 

  1. Turn ignition switch ON and select DATA MONITOR mode with CONSULT-II. See Figure
  2. Crank engine for at least 2 seconds and run it for at least 5 seconds at idle speed.
  3. If 1st trip DTC is detected, go to Diagnostic Procedure, DIAGNOSTIC PROCEDURE  .

    If 1st trip DTC is not detected, go to next step.

  4. Maintaining engine speed at more than 1,000 rpm for at least 5 seconds.
  5. If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE 

With GST 

Follow the procedure With CONSULT-II.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.