2004 Infiniti I35FACTORY OEM SERVICE PROCEDURE

Diagnostic Procedure

  1. CHECK ENGINE COOLANT TEMPERATURE SENSOR 
    1. Turn ignition switch OFF.
    2. Remove engine coolant temperature sensor.
    3. Check resistance between engine coolant temperature sensor terminals under the following conditions.
      Fig 1: Checking Engine Coolant Temperature Sensor
      G00786596Courtesy of NISSAN MOTOR CO., U.S.A.

      OK or NG 

    1. OK: INSPECTION END 
    2. NG: Replace engine coolant temperature sensor.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.