Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Procedure
- CHECK ENGINE COOLANT TEMPERATURE SENSOR
Check resistance between engine coolant temperature sensor terminals 1 and 2 as shown in Figure .
OK or NG
- OK: GO TO 2.
- NG: Replace engine coolant temperature sensor.
- CHECK THERMOSTAT OPERATION
When the engine is cold [lower than 70° C (150° F)] condition, grasp lower radiator hose and confirm the engine coolant does not flow.
OK or NG
- OK: GO TO 3.
- NG: Repair or replace thermostat. Refer to THERMOSTAT .
- CHECK INTERMITTENT INCIDENT
- Refer to TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT .
- Refer to WIRING DIAGRAM .
- : INSPECTION END
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
