Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Infiniti FX45FACTORY OEM SERVICE PROCEDURE
Diagnostic Procedure
- Check ECM Power Supply
- Turn ignition switch OFF.
- Disconnect ECM harness connector.
- Check voltage between ECM terminal 121 and ground with CONSULT-II or tester.
- Voltage: Battery voltage
OK or NG
- OK: go to 3 .
- NG: go to 2.
- Detect Malfunctioning Part
Check the following.
- Harness connectors E211, M41
- 20A fuse
- IPDM E/R harness connector E8
- Harness for open or short between ECM and battery
- Repair or replace harness or connectors.
- Check Intermittent Incident
Refer to TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT .
OK or NG
- OK: go to 4.
- NG: Repair or replace harness or connectors.
- Perform DTC Confirmation Procedure
With CONSULT-II
- Turn ignition switch ON.
- Select SELF DIAG RESULTS mode with CONSULT-II.
- Touch ERASE.
- Perform DTC confirmation procedure .
- Is the 1st trip DTC P1065 displayed again?
With GST
- Turn ignition switch ON.
- Select MODE 4 with GST.
- Touch ERASE.
- Perform DTC confirmation procedure .
- Is the 1st trip DTC P1065 displayed again?
Yes or No
- Yes: go to 5.
- No: Inspection end
- Replace ECM
- Replace ECM.
- Perform initialization of NATS system and registration of all NATS ignition key IDs. Refer to ECM RE-COMMUNICATING FUNCTION .
- Perform ACCELERATOR PEDAL RELEASED POSITION LEARNING .
- Perform THROTTLE VALVE CLOSED POSITION LEARNING .
- Perform IDLE AIR VOLUME LEARNING
.
- Inspection end
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
