2004 Infiniti FX45FACTORY OEM SERVICE PROCEDURE

Testing Condition

  • For best results, perform at ambient temperature of -10° C (14° F) or higher.
  • For best results, perform at engine COOLANT temperature of -10° C (14° F) to 60° C (140° F).

With CONSULT-II 

  1. Replace thermostat with new one. Refer to THERMOSTAT AND WATER CONTROL VALVE . Use only a genuine NISSAN thermostat as a replacement. If an incorrect thermostat is used, the MIL may come on.
  2. Turn ignition switch ON.
  3. Select COOLANT TEMP/S in DATA MONITOR mode with CONSULT-II.
  4. Check that the COOLANT TEMP/S is above 60° C (140° F).

    If it is below 60° C (140° F), go to following step.

    If it is above 60° C (140° F), cool down the engine to less than 60° C (140° F), then retry from step  1 .

  5. Drive vehicle for 10 consecutive minutes at speed of 50-75 MPH (80-120 KM/H).

If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE  .

With GST 

  1. Follow the procedure With CONSULT-II above.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.