Name: AllOEMManuals
Address: 316 Brandywine Ave, Streetman, TX, 75859, US
Telephone: +14699867883
Price range: $$

NOTE:

Do not use the "function test" for diagnosis. For more information, refer to the separate volume "CONSULT-II OPERATION MANUAL (Function Test)".
When CONSULT-II is connected and communicating, ABS warning lamp, SLIP indicator lamp, and VDC OFF indicator lamp turn on, and when the communication is interrupted, the lamps will turn off after approximately 2 to 3 sec.
When the self-diagnosis, data monitor, or active test functions are being executed, EBD, ABS, TCS, and VDC control is not performed.
When using CONSULT-II to perform ABS actuator and electric unit (control unit) self-diagnosis, active test, work support, etc., first stop engine, connect CONSULT-II, and select "ABS".
When an error is shown by the CONSULT-II SELF-DIAG RESULTS and CONSULT-II is used to perform an active test, an engine system malfunction may be shown, but restarting engine will return the status to normal.
When data monitoring is executed by using CONSULT-II, a malfunction code may be indicated as the result of the real time diagnosis. In such a case, execute data monitoring in manual mode. Refer to CONSULT-II Operation Manual.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Consult-II Functions: Notes