Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Infiniti FX45FACTORY OEM SERVICE PROCEDURE
Diagnostic Procedure
- Check DTC With TCM
Check DTC with TCM. Refer to ON BOARD DIAGNOSTIC (OBD) SYSTEM .
OK or NG
- OK: go to 2.
- NG: Perform trouble shooting relevant to DTC indicated.
- Check DTC With ABS Actuator And Electric Unit (Control Unit)
Go to TROUBLE DIAGNOSIS .
OK or NG
- OK: go to 3.
- NG: Repair or replace.
- Check DTC With And Unified Meter And A/C AMP
.
Refer to UNIFIED METER AND A/C AMP .
- Inspection end
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.