Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Testing Condition
- For best results, perform at ambient temperature of -10° C (14° F) or higher .
- For best results, perform at engine coolant temperature of -10° C (14° F) to 60° C (140° F) .
With CONSULT-II
- Replace thermostat with new one. Refer to WATER INLET AND THERMOSTAT ASSEMBLY .
- Turn ignition switch ON.
- Select COOLAN TEMP/S in DATA MONITOR mode with CONSULT-II. See Figure.
- Check that the COOLAN TEMP/S is above 60° C (140° F).
If it is below 60° C (140° F), Go to following step.
If it is above 60° C (140° F), cool down the engine to less than 60° C (140° F), then retry from step 1.
- Drive vehicle for 10 consecutive minutes at a speed of 50-75 MPH (80-120 Kph.).
If 1st trip DTC is detected, Go to DIAGNOSTIC PROCEDURE
With GST
- Follow the procedure with CONSULT-II above.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.