Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
CLSD THL Pos, ACCEL Sen 1, THRTL Sen 1
Below is the data for CLSD THL POS, ACCEL SEN 1 and THRTL SEN 1 when depressing the accelerator pedal with the ignition switch ON and with selector lever in D position.
The signal of ACCEL SEN 1 and THRTL SEN 1 should rise gradually without any intermittent drop or rise after CLSD THL POS is changed from ON to OFF.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.